Honeycomb fascia reproductions We made this neck for

We made this neck for a radiator shop because the brass was stress cracked and fatigued beyond salvage

500 and 550)

The lower priced Harrison Recirculating Heater Core generated less heat

Single stud mount (or formed brass fork)

dropping the core lower in the frame

Honeycomb fascia reproductions We made this neck forWe utilize a metal honeycomb pattern fascia to mimic the core pattern used in early Chevrolet radiators. It has 1 4" depth and is 1 4" across the flats. When placed against a 10 or 11 FPI core it resembles the OE core pattern but without the cost. It will push the core back toward the core 1 4" but not encroach on the fans space. You must design and construct a radiator to accommodate the fascia depth or it will not fit.