DEI Heat Sheath - 1"x36" designed to sit directly on

designed to sit directly on the carburetor allowing easy access for tuning while catching dirt and debris before it can be sucked into the race engine

Performance Benefits

With the nut off the lower ball joint

Angle slot keeps rear end track linked up

5" GN 5x5 Rear

DEI Heat Sheath - 1"x36" designed to sit directly onHeat Sheath is made from a Hi Temp fiberglass fabric bonded to an aluminized material then sewn into a tube. Designed to slide over wires and hoses this product can be easily shaped to fit the tightest bends. The Heat Sheath will reflect up to 90% of the radiant heat and can insulate against up to 500 degrees direct continuous heat. Easily cut to length with scissors or a sharp knife. Reflects heat from wiring and hoses