Kawasaki 1 Inch 140 Pump Spacer Made from all anodized aluminum

Made from all anodized aluminum and high temp silicone rubber

This bearing assembly allows the use of Kawasaki driveshafts in Yamaha hulls

and never worry about the gasket again

There is 4 years of R&D that went into making these mounts the best you can buy for your vintage ski

This allows you to convert your stock Kawasaki 900-1100 intake manifold to a speed plate system and converts to 38mm Mikuni carbs from a Yamaha 1100 engine

Kawasaki 1 Inch 140 Pump Spacer Made from all anodized aluminumUse this spacer to remove the trim assembly from the Kawasaki X2. You can also use this to move the steering back 1 inch on any Kawasaki hull with a 140 pump. Made from billet 6061 and anodized for corrosion resistance.