Pay in 4 interest-free payments of $36.25 Learn more
Ships within 48 hours · Estimated delivery Aug 10 - Aug 15
Stainless Bearing and high quality seals are included and pre-installed
This conversion kit is simple to complete
and never worry about the gasket again
There is 4 years of R&D that went into making these mounts the best you can buy for your vintage ski
There are o-rings in between the plates so no gaskets to replace when pulling the carbs in and out of your engine compartment
Blaster Engine Setback Kit Stainless Bearing and high qualitySetback kit for Blaster twin cylinder motor. This kit allows you to move the motor back 1" 1 1 4". You can use a custom midshaft to move back 1 1 4" or use a gp760 midshaft and move the motor back 1". Helps to give the boat a little change in attitude and helps getting the nose up for freestyle. Includes motor plates, motor mounts and all hardware to make the swap. Uses oem #65v 51323 00 00 midshaft.
US$ 89.00
US$ 89.00
US$ 50.00
US$ 89.00
US$ 89.00
US$ 89.00
US$ 89.00
US$ 55.99
US$ 55.99
