Pay in 4 interest-free payments of $47.66 Learn more
Ships within 48 hours · Estimated delivery Nov 5 - Nov 10
This bolt on side cutter (can be welded on) is designed for mini-excavator buckets and has an industry standard part number 20s-70-71330 also known as MSC-R
A bucket pin shim will work just fine if it is a little larger than the Outer Diameter of your pin but not if it is smaller (it has to fit around the pin)
This tooth uses pin 2MG10/15PR our # MG10/15PR
2 pads are used on each stabilizer arm
This bolt on End Bit has an industry standard part number of T207993 and has 6 bolt holes
1/2X4X96FSB Bucket Pin This bolt on side cutter1 2" x 4" x 96" Flat single bevel, weld on cutting edge. Good to weld under the front edge of your bucket to give it a wear surface or to replace the front lip of your bucket. If it becomes the new front lip of your bucket you can drill or blow holes in it to match a bolt on edge if you like.
