Freud Fine Finish Crosscutting (Thin Kerf) Saw Blades Over the Post The negative hook angles make

The negative hook angles make flat bottom grooves and virtually splinter-free cuts

Recommended use - final sanding and surface preparation for stain/varnish

It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability

followed by four alternate top bevel teeth for crosscutting and a large gullet for effective chip clearance

Brass sleeve size: 8" x 1-1/4"

Freud Fine Finish Crosscutting (Thin Kerf) Saw Blades Over the Post The negative hook angles makeThis Perma SHIELD coated blade gives new life to underpowered saws and produces smooth crosscuts in hardwoods, softwoods and moldings. Coated blades pull 1 3 less on the saw, which translates into 33% more cutting power. Thin kerf blades remove less material than standard carbide blades, thus requiring less horsepower to produce equally good results.