PBSS-UH-050 Standard Duty Stamped Stainless Steel Pillow Block Mounted Bearing w/ UHMW-PE Insert 1-9/16" ID Design fully engages the shaft

Design fully engages the shaft without marring

Does not mar the shaft

Allows you room to re-bore the ID without damaging the clamp screws

Includes 2 rubber grommets to reduce vibration & noise

Bearing insert with 2 set screws has longer inner race for added load support

PBSS-UH-050 Standard Duty Stamped Stainless Steel Pillow Block Mounted Bearing w/ UHMW-PE Insert 1-9/16" ID Design fully engages the shaftUSDA & FDA approved. For wash down applications in wet or harsh environments or where sanitary conditions are a factor. Self lubricating bearings resist corrosion, high impact and abrasion. Two piece stainless steel housing units. Tolerates 60 to 180 F. View Catalog Page